1.
Heat a small pan and keep flame to a low. Add 1 teaspoon ajwain (carom seeds).
2.
Stirring often roast ajwain for some seconds till they are aromatic. No need to brown them. Let them cool down.
3.
Then add them in a small dry grinder jar or a spice grinder.
4.
Grind to a fine powder. Keep aside. You can even crush ajwain in a mortar-pestle. In this case, when adding ajwain, use a tea strainer and sift the ajwain powder through it. This is done so that when pressing through the sev maker, the dough strands do not break.
5.
In a mixing bowl or pan take 1 cup besan (gram flour) and ½ cup rice flour.
6.
Add the ground ajwain powder.
7.
Then add 1 generous pinch asafoetida (hing), 2 pinches turmeric powder, ÂĽ teaspoon red chilli powder and 1 teaspoon salt. You can add salt as per taste. Turmeric powder can be skipped. For a spicy omapodi, you can increase the amount of red chilli powder. For more crispiness you can add a pinch of baking soda also.
8.
Mix very well with a spoon or spatula.
9.
Now heat 1 tablespoon oil in a steel bowl or a steel measuring cup.
10.
When the oil becomes hot, add it to the flour mixture. Instead of oil you can also use ghee or butter.
11.
Now add water in parts. First add 2 to 3 tablespoons of water. Mix well and begin to knead to a smooth dough. Overall I used 7 tablespoons of water. You can add 6 to 7 tablespoons of water depending on the quality of besan and rice flour.
12.
Knead to a smooth dough. If the dough becomes sticky, then you can add some more besan. If the dough looks dry, then add some more water and knead again. Cover the bowl.
13.
Use the disc shown in the below picture for preparing omapodi. You can even use the disc with fine holes. Also heat a kadai and add oil as required for deep frying omapodi.
14.
Apply some water or oil in the sev/murukku maker. Then take a portion of the omapodi dough and place it inside the sev maker. Cover with the top part and keep aside.
15.
Let the oil in the kadai become medium hot. Check the oil temperature by adding a small tiny piece of the omapodi dough. If the small piece of dough comes up gradually and steadily on top, the oil is hot enough to fry. If it comes up too quickly, then oil is too hot. If it settles down at bottom of kadai or comes up very slowly, the oil is not hot enough for frying omapodi.
16.
When the oil is hot enough, directly press holding the sev maker on top of the oil and let the sev directly fall in the oil. While pressing rotate in a concentric circle from the center to outwards similar to making a chakli. Do not over crowd the kadai with omapodi. Add as much as needed without overcrowding the kadai. Be careful when pressing the sev in the oil. After the sev is pressed in the oil, break the top sev strands with a spoon or knife and let the sev strands fall in the oil.
17.
When the oil is hot enough, directly press holding the sev maker on top of the oil and let the sev directly fall in the oil. While pressing rotate in a concentric circle from the center to outwards similar to making a chakli. Do not over crowd the kadai with omapodi. Add as much as needed without overcrowding the kadai. Be careful when pressing the sev in the oil. After the sev is pressed in the oil, break the top sev strands with a spoon or knife and let the sev strands fall in the oil.
18.
Gently begin to turn with a slotted spoon.
19.
Now fry the second side. You can turn over a couple of times for even frying.
20.
When the oil stops sizzling, continue to fry for some more seconds till the omapodi are golden and crisp. Turn over as needed when frying. Do not break the sev while frying as then it becomes extra work to remove the small pieces of sev from the oil. So fry the entire round shaped omapodi as one piece and do not break it.
21.
Once done then remove omapodi with a slotted spoon or a strainer spoon draining off the extra oil. Place them on kitchen paper towels. Fry the remaining omapodi in the same way.
22.
When the omapodi are cooled, then place them in an air tight container or box. Break omapodi before adding in the mixture.
23.
Take ½ cup besan (gram flour) and 1 tablespoon rice flour in a mixing bowl. Then add 1 pinch asafoetida (hing), 1 pinch of baking soda, 2 pinches turmeric powder and ½ teaspoon salt.
24.
Mix everything with a spoon. Now add 8 to 9 tablespoons water in parts.
25.
Using a wired whisk make a smooth and slightly thin batter without lumps. The batter consistency is slightly thin. The amount of water to be added depends on the quality of gram flour. So add accordingly.
26.
Heat oil for frying in a kadai or pan. When the oil becomes hot, then tap the wired whisk or the handle of a spoon which has a bit of batter in to the hot oil.
27.
Now take a dry perforated ladle/jhara and place it above the hot oil. Don't keep too much on a height, as the batter droplets, when falling from a height, do not give a round shape. With a spoon add some batter on the perforated spoon ladle/jhara. Spread the batter lightly with a spoon. Finish up the batter on the perforated spoon ladle this way.
28.
On a medium flame begin to fry the boondis. Do not turn them. Let them become slightly crisp and then turn them. When the boondis have become crisp, turn them with a slotted spoon. You won't get perfect round shape for each boondi, but it does not matter as the taste of homemade boondi is better than store brought ones.
29.
After the oil stops sizzling, continue to fry the boondis for some more seconds so that they become crisp. Remove with a strainer spoon or a slotted spoon draining the extra oil.
30.
Now take thick poha.Stirring often with a spoon fry poha till they are crisp and pale golden. Don't brown the poha. I have used thick poha. You can also use thin poha. Once the poha is fried well, then drain off the extra oil using the same ladle.Place the fried poha on the same kitchen paper towel. Next add curry leaves. stirring often fry curry leaves till they become crisp Curry leaves take a few seconds to fry. place the fried curry leaves on the kitchen paper towel.
Write Review
x